The Jaw Variety couplings are presented while in the industry?¡¥s greatest variety of stock bore/keyway combinations. These couplings need no lubrication and give remarkably trusted service for light, medium, and heavy duty electrical motor and inner combustion electrical power transmission applications.
Functions
Fail-safe ¡§C will nevertheless complete if elastomer fails
No metal to metal contact
Resistant to oil, filth, sand, moisture and grease
A lot more than 850,000 combinations of bore sizes
Most varieties obtainable from stock in 24 hours
Applications contain power transmission to industrial gear including pumps, gear boxes, compressors, blowers, mixers, and conveyors. Jaw Form couplings are available in 24 sizes from a minimum torque rating of three.5 in¡§Clbs to a optimum torque rating of 170,004 in¡§Clbs along with a bore variety of .125 inches to 7 inches.Our conventional bore system covers AGMA, SAE, and DIN bore/keyway and spline bore combinations.
The Jaw Variety coupling is available within a selection of metal hub and insert supplies. Hubs are supplied in sintered metal, aluminum, bronze, steel, stainless steel, and ductile iron.
L Form
Coupling gives normal shaft-to-shaft connection for general industrial duty applications
Regular L Form coupling hub products are either sintered iron or cast iron
LC Form
Uses the common L Type hubs using a snap wrap spider and retaining ring
Suited for applications above 1,750 RPM
AL Sort
Aluminum hubs provide light bodyweight with lower overhung load and low inertia
Great resistance to atmospheric disorders, perfect for corrosive natural environment applications
SS Kind
The SS Variety coupling supplies greatest safety against harsh environmental problems
Sizes SS075-SS150 accessible from stock, other sizes readily available on request
RRS Type
Center ?¡ãdrop out?¡À area of this coupling presents correct shaft separation, although also allowing uncomplicated elastomer set up devoid of disturbing the hubs or requiring the realignment of shafts
Accommodates American and European marketplace typical pump/motor shaft separations
The spacer is produced of glass reinforced plastic, cast iron, or aluminum
SW Sort
Common L Type coupling by using a snap wrap elastomer with retaining ring
Nicely suited for common shaft to shaft connection on the whole industrial function applications beneath 1,750 RPM
C & H Sorts
Couplings offer conventional shaft-to-shaft connection for medium (C) and Hefty (H) duty selection applications
Standard C coupling hub is manufactured of cast iron, even though the H is constructed of ductile iron