Energy UNITS FOR LIFT TABLE one
Standard Description
This energy unit is designed exclusively for your little lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit is broadly made use of within the business of logistic gadgets like minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed from the solenoid valve with the speed managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Common Description
This power unit is created solely for that medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve plus the pace managed by the adjustable needle valve. Once the lift rises to a high positoin, but the power provide is reduce, the decreasing movement is managed through the guide override perform.
Power UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is built exclusively for the substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve and the velocity controlled by a stress compensated flow manage valve.
Energy UNITS FOR LIFT TABLE 4
Common Description
This energy unit is intended exclusively for your massive lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve and also the velocity managed from the adjustable needle valve. When the lift rises to a large positoin, but the energy supply is lower, the decreasing movement is controlled by the manual override perform.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, which can only operate intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned just before installation of the energy unit.
three. Viscosity of the oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is recommended.
four. Oil changing is needed soon after the original a hundred operation hours,afterwards after each 3000 hrs.
5. The electrical power unit proven is made to be mounted vertically.